woshifanka
Full Member level 1
hi all :
when we research the antenna's pattern. how to set to get the co and cross pol ?
for example: if i want to get the XZ plane then i should do as follows:
1) hfss-->result-->create report
2)report type: Far Fields & Display type: Radition Pattern
3) in the sweep tab, select Phi under the name column, and on the drop list, select Theta, which changes theprimary sweep to Theta.
Then how to set to get the co and cross pol ? since i don't know how to set it in HFSS , wish your help.
i will appreciate your help a lot
thanks in advance.
kaka
ps: supposed the coordinate is like the figure attached , and generally it is in hfss's default mode
Added after 1 hours 18 minutes:
can 't attach the figure . ..
the patch width is along x axis , and the patch length along y axis. z axis is vertical to the xy plane .
thanks
kaka
when we research the antenna's pattern. how to set to get the co and cross pol ?
for example: if i want to get the XZ plane then i should do as follows:
1) hfss-->result-->create report
2)report type: Far Fields & Display type: Radition Pattern
3) in the sweep tab, select Phi under the name column, and on the drop list, select Theta, which changes theprimary sweep to Theta.
Then how to set to get the co and cross pol ? since i don't know how to set it in HFSS , wish your help.
i will appreciate your help a lot
thanks in advance.
kaka
ps: supposed the coordinate is like the figure attached , and generally it is in hfss's default mode
Added after 1 hours 18 minutes:
can 't attach the figure . ..
the patch width is along x axis , and the patch length along y axis. z axis is vertical to the xy plane .
thanks
kaka