Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
when i use the glcd library in mikroc,i get some errors.
Unresolved extern GLCD_CS1
Unresolved extern GLCD_CS2
this is because i am not declaring these pins.as my glcd do not has these pins.so what should i have to do to resolve the errors.
On some graphic LCDs the enables are for different regions of the display. I suspect the two enables on that device are for the top and bottom halves of the pixel map so they need to be driven according to the position of the pixel you are addressing. You need to connect both back to the PIC and allocate pins for them to connect to.
GLCD_CS1 is the same as E1 and GLCD_CS2 is the same as E2.
I know that dual CS for segmented memory is pretty standard for graphic LCD. But there's no indication that this graphics controller uses it.
Generally GLCD drivers are very hardware dependent. The mikroC is said to work for KS108/KS107 controller, it most likely won't work for this chip without serious rework.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.