simon_12
Junior Member level 3
Hello
I am using student version of C18 Compiler v3.31 for pic 18f4550. The programmer which is used by me is Genius G540 programmer. when i load the hex file into the buffer , it gives the following message
" None configuration worde in the hex file"
"Please set it after loading"
what does it mean?
After that when i click the program button , only erase operation is successful , the blank,verify, program and encrypt operation gives the error.
Please tell me where i am doing wrong? i have already set the configuration bits of pic18f4550 in the programming software( Genius G540).
Regards
Simon
I am using student version of C18 Compiler v3.31 for pic 18f4550. The programmer which is used by me is Genius G540 programmer. when i load the hex file into the buffer , it gives the following message
" None configuration worde in the hex file"
"Please set it after loading"
what does it mean?
After that when i click the program button , only erase operation is successful , the blank,verify, program and encrypt operation gives the error.
Please tell me where i am doing wrong? i have already set the configuration bits of pic18f4550 in the programming software( Genius G540).
Regards
Simon