Error when launching PCB Navigator

[manishyamdagni]

About PCB Navigator

Hello All Friends,

I have a problem with PCB Navigator after installation when I try to start it, it will give a error message THE APPLICATION FAILED TO INTIALISE PROPERLY as seen in attached file.

Please help to get out of this error, Thanks in advance.

 

[ylscqu]

About PCB Navigator

Perhaps license conflict

 

[binu G]

About PCB Navigator

Try reinstalling the navigator.
which version of the navigator you use ?

binu g

 

[manishyamdagni]

Re: About PCB Navigator

Hi,

I've installed version 3, I think it is freeware so there shouldn't be license problems

manish

 

[binu G]

About PCB Navigator

version 3 is not the primary problem. it also depend on the host tools you are using.
for example if u try to use the nav3 for orcad10 or above it will not work. so better confirm the same.

else specify the tools you want to interlink.

 

[concat]

Re: About PCB Navigator

Use PCB Navigator V5 for Orcad 10.xx but I also install PCB Navigator 4.01 on Orcad 10, it also run, but the feature of PCB Navigator can't run on menu of Orcad 10.

Good luck