Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The display surely is code controlled, thus it's a good idea to search the code for the "IF" ...to know know the reason why it shows this message.
Or read the documentatiin of the code...
Very simple my friend.... You need to check if the H-bridge drivers are driving the signal to your mosfet bank, if yes connect your transformer and make sure you connect your feedback loop, if there is no feedback it will show no feedback on your lcd display... If you still have challenges please tell me..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
