Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Difference between RS232 & RS485/488

Status
Not open for further replies.

Vishal500

Newbie level 3
Newbie level 3
Joined
May 11, 2007
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,307
difference between rs232 and rs485

Difference between RS232 & RS485/488
 

rs232 rs485 difference

RS232
full duplex
point to point
short distance(1 meter) at 115kbaud
at least 3 wires (more with handshake control)

RS485
half duplex
point to multi-point (master to multiple slaves)
1200 m distance at 115kbaud
2 wire (RS422 uses 4 wires)

Added after 29 seconds:

RS232
full duplex
point to point
short distance(1 meter) at 115kbaud
at least 3 wires (more with handshake control)

RS485
half duplex
point to multi-point (master to multiple slaves)
1200 m distance at 115kbaud
2 wire (RS422 uses 4 wires)
 

different between rs232 and rs485

adding to what klystron said , RS485 line is differential but RS232 is not,and this is why RS485 can be used for longer distances.
 

RS232
-Unbalanced / non-differential (all same terms)
- point to point
-No. of Drivers = 1
-No.of receivers =1
-full duplex (so it can be half duplex also)
-Distance (Standard) = 15m
- receiver input sensitivity( a valid signal) = +-3V
- Max speed at 12m = 20kbps

RS485
- Balanced. differential
- No.Drivers = 32
- No.of Receivers = 32
- multipoint
- Half duplex
- Distance (standard) = 1200m
- receiver input sensitivity( a valid signal) = +-200mV
- Max speed at 12m = 35Mbps
 

RS232
-Unbalanced / non-differential (all same terms)
- point to point
-No. of Drivers = 1
-No.of receivers =1
-full duplex (so it can be half duplex also)
-Distance (Standard) = 15m
- receiver input sensitivity( a valid signal) = +-3V
- Max speed at 12m = 20kbps

RS485
- Balanced. differential
- No.Drivers = 32
- No.of Receivers = 32
- multipoint
- Half duplex
- Distance (standard) = 1200m
- receiver input sensitivity( a valid signal) = +-200mV
- Max speed at 12m = 35Mbps
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top