Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Designing a coaxial cavity duplexer

Status
Not open for further replies.
R

RFDesigner1212

Newbie
Joined
Sep 13, 2022
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
31
I have designed a coaxial cavity duplexer. The results are good in the simulations and now I need to get it machined (aluminium block) and plated (silver). I am not so sure about how to decide the plating thickness. I know it depends on the operating frequency and the skin depth. Are there any other considerations in deciding this?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top