tony_taoyh
Full Member level 2
Hi,
Now I am design one double balanced mixer,
using Schottky Barrier Diode Quads.
The final layout (draft) is attached.
Can anyone give me some advice on the following issues:
(1) Ribbon wire, Can I use Ribbon wire to cross another transmission
line vertically, or some angle (< 90) needed?
(2) Because, I have two balun, one for LO, another for RF,
which balun should I put the diode near to? RF one or LO one?
Thanks a lot.
Best Regards,
Tony
Now I am design one double balanced mixer,
using Schottky Barrier Diode Quads.
The final layout (draft) is attached.
Can anyone give me some advice on the following issues:
(1) Ribbon wire, Can I use Ribbon wire to cross another transmission
line vertically, or some angle (< 90) needed?
(2) Because, I have two balun, one for LO, another for RF,
which balun should I put the diode near to? RF one or LO one?
Thanks a lot.
Best Regards,
Tony