Deexith Hasan
Advanced Member level 4
using transformer input is 220 o\p 12 volt rms. bridge drop is 1.4v [full wave rectifier] so o\p is 10.6 volt...
how to find the filter capacitor needed if load is 1k.
10.6 volt rms after filtering i should get 10.6*sq.root (2)=14.9 volt but getting 8.98v..... y???
i need to measure ac voltage so using this setup
how to find the filter capacitor needed if load is 1k.
10.6 volt rms after filtering i should get 10.6*sq.root (2)=14.9 volt but getting 8.98v..... y???
i need to measure ac voltage so using this setup