agge
Newbie level 1
Hi everyone!
I'm trying to design a tapered microstrip to parallel stripline balun in ADS. I have imported the layout in .dxf with three different layers (upper conductor, dielectric and bottom conductor/ground).
My question is about how to match each substrate layer with its corresponding layout layer. Will ADS understand that the ground layer tapers and turns into stripline?
I hope anyone can help me.
Thanks,
Agge
I'm trying to design a tapered microstrip to parallel stripline balun in ADS. I have imported the layout in .dxf with three different layers (upper conductor, dielectric and bottom conductor/ground).
My question is about how to match each substrate layer with its corresponding layout layer. Will ADS understand that the ground layer tapers and turns into stripline?
I hope anyone can help me.
Thanks,
Agge