nicksydney
Junior Member level 3
Hi,
I just bought a small DC motor to experiment on how to control it. I've got a STM32 Cortex-M3 dev board (attached in this post). I know how to program the board and run an app I need guidance from the expert whether what I'm doing is the right thing.
What I plan to do is connect the (+) of the motor to one of the available GPIO pin and the (-) to the GND of the available pin and then write a program to enable the (+) pin is this right ? and once the program is running what kind of data must I send to the pin ?
Can anybody please help.
Thanks
I just bought a small DC motor to experiment on how to control it. I've got a STM32 Cortex-M3 dev board (attached in this post). I know how to program the board and run an app I need guidance from the expert whether what I'm doing is the right thing.
What I plan to do is connect the (+) of the motor to one of the available GPIO pin and the (-) to the GND of the available pin and then write a program to enable the (+) pin is this right ? and once the program is running what kind of data must I send to the pin ?
Can anybody please help.
Thanks