Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

DC-DC Switched-Mode Power Supply System

Status
Not open for further replies.

bharath_k

Junior Member level 3
Junior Member level 3
Joined
Jun 8, 2018
Messages
31
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
244
Hello All,

I designed a system to convert from 1.8V to 3.3V. I have the schematic diagram as shown below.

sche_reg_chargepump.PNG

I am running corner analysis and it passes all the corners except in SS_pre as shown below. I get ripples. When I see the switching of the comparator is slow. From what I can see either it is slow from the voltage divider to the input of comparator or the comparator itself is slow. Can anyone suggest how can I find the which of the two is causing me the problem?

outp.PNG

Thanks in advance!

Regards,
Bharath
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top