deeplearns
Member level 4
Hi Friends ,
I am using PIC 18F4520 (Instruction cycle 125 ns )to run a bipolar stepper motor . I need to give the driver card clock pulses .
But whatever I set the timer value to It does not generate a clock pulse ;lesser than 16 ms ..8 on , 8 off .
I have checked the pulses in Proteus , also with a CRO .
But when I just tried the same using delay function it works exactly fine .
Please help .
I am using PIC 18F4520 (Instruction cycle 125 ns )to run a bipolar stepper motor . I need to give the driver card clock pulses .
But whatever I set the timer value to It does not generate a clock pulse ;lesser than 16 ms ..8 on , 8 off .
I have checked the pulses in Proteus , also with a CRO .
But when I just tried the same using delay function it works exactly fine .
Please help .