Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
it have other way? if i have not schematic(brd file only). for mentor PADS it can right click and then edit footprint direct. and replace in eco mode easy. no change schematic.
No in allegro it is not like that you have to do it through schematic.
There is one way but I dont remember exactly it was through netlogic command i think try that option (you will need correct footprint and device files for that)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.