Can The MiniPOV3 be used with Atmega 16

[Eng.Mohd.Salah]

Guys, im wondering .. plz help me.. i see here the MiniPOV3 programmer can be used just with ATTiny, but...

Q1: Can i use " The MiniPOV3 uses the serial "DASA" circuit " programmer with ATmega (8,16 and 32) without any problems?????????
======================================================
Q2: i found that DASA pins can be interfaced the ATTiny2313 uC with the PC, such as :
DASA
RESET = RTS
SCK = DTR
MOSI = TXD
MISO = CTS

But, when i was reading the ATTiny 2313 datasheet, i doesn`t find the pin "SCK"....
Where is it ????!!!!!
======================================================
Q3: plz can you show me the usb/serial converter that i must use it with the above circuit...
======================================================
Q4: Can i used a Ponyprog2000 to burn the hex code????
======================================================

 

[tpetar]

AVR In-Circuit Serial Programmer
https://electronics-diy.com/avr_programmer.php

For ATTiny2313 programming pins are:




Best regards,
Peter

:wink: