Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Binocular to toroidal transformer conversion in linear

Status
Not open for further replies.

neazoi

Advanced Member level 6
Advanced Member level 6
Joined
Jan 5, 2008
Messages
4,148
Helped
13
Reputation
26
Reaction score
15
Trophy points
1,318
Location
Greece
Activity points
37,119
Hello, I have successfully built this little linear **broken link removed**
I wish to convert the output and input transformers from binocular to toroids, as these are easier to find and wind.

I would like your suggestions of if this can be done and how to wind these toroids.
 

If you want something easy to wind look at "pot cores" or "EI" cores. Both of these take a separate spool that you wind and then place in the core. Toroids are a pain to wind without expensive specialized equipment.

If you must wind a small toroid by hand it may help to solder a short stiff piece of wire to the end of the winding to serve as a needle to poke through the hole.
 
  • Like
Reactions: neazoi

    neazoi

    Points: 2
    Helpful Answer Positive Rating
If you want something easy to wind look at "pot cores" or "EI" cores. Both of these take a separate spool that you wind and then place in the core. Toroids are a pain to wind without expensive specialized equipment.

If you must wind a small toroid by hand it may help to solder a short stiff piece of wire to the end of the winding to serve as a needle to poke through the hole.

Obviously this has to be made using some FT23 or FT37 toroids and they have big holes. The amount of turns required also is small. These are also more widely available and cheap.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top