Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

are these layouts manufacturable?

Manufacturable?

  • Yes, thats totally ok

    Votes: 0 0.0%
  • No

    Votes: 0 0.0%
  • yes, but not recommended, since

    Votes: 0 0.0%

  • Total voters
    0
Status
Not open for further replies.

seen25

Newbie level 5
Newbie level 5
Joined
Mar 30, 2007
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,359
ic layouts and overlapping

they passed drc, but I am wondering

I attached two files,
in the first one, poly curls over the active, is it allowed?

in the second, one the pmos is turned 90 degrees,
 

yes you can have 90 degree or even 45 degree gates but you will get size discrepencies.

As long as the poly does not overlap the active 50/50 (example) it would not fail drc, there will be miniumum spacing between poly to active overlap.
 

    seen25

    Points: 2
    Helpful Answer Positive Rating
That's correct. It will be perfectly doable.

As stated before, you can perfectly have 90 or 45 degrees bend gates (actually is an usual technique in big MOS, in order to gain effective transistor area...)

In this case you might consider that the "real" silicon transistor will be slightly different to the symbol values placed in the schematics...

Beyond that, if no rule is violated (that's the case) DRC will be clean and that's correct.
 

    seen25

    Points: 2
    Helpful Answer Positive Rating
it can be. but it's better if they all have followed the same orientation.
 

    seen25

    Points: 2
    Helpful Answer Positive Rating
The layout should be fine as long as DRC/LVS passed...and if you're circuit designer will agree with you.
 

DRC only check the violation for manufatured, they do not consider the parasitics, if you want performance and high yield , you should modified the layout
 

1) in digital we can use any orientation , but in analog we should follow same orientation.

2) DRC and LVS no problem , but overlapping will produce parasitic capacintance that increases delay, as possiblly we must avoid overlapping.

i think these are correct . can anybody comment pls.

Added after 1 hours 40 minutes:

we can follow different orientations in digital, but in anlog only we must follow same orientation for matched transistors, because the transconductances of the transistors are same which are placed in same orientation, this will avoid current mismatches.
 

gksivas said:
in anlog only we must follow same orientation for matched transistors, because the transconductances of the transistors are same which are placed in same orientation, this will avoid current mismatches.

Is this also related to the effect of crystal orientation so we make matched transistor with same orientation?
 

quaternion, That's correct, MOS transistors oriented in the same direction match better than those with different orientation due to the anisotropic nature of monocrystalline silicon.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top