vickyuet
Member level 2
Dear,
I know the difference b/w initial and always construct but I had found a bug during its use in stopping a simulation in Modelsim.
1- initial # 500 $stop; worked well and stops the simulation precisely at 500 time units.
2-always@* # 500 $stop; sets up an infinite loop and simulation failed to stop unless we exit modelsim....
I knew always constructs run continuously but I am forcing it to stop then it might Why infinite loop set up:?:.Kindly guide/correct me
Regards 8-O
I know the difference b/w initial and always construct but I had found a bug during its use in stopping a simulation in Modelsim.
1- initial # 500 $stop; worked well and stops the simulation precisely at 500 time units.
2-always@* # 500 $stop; sets up an infinite loop and simulation failed to stop unless we exit modelsim....
I knew always constructs run continuously but I am forcing it to stop then it might Why infinite loop set up:?:.Kindly guide/correct me
Regards 8-O