aleksaZR
Newbie level 6
Say I have 3 nets: 5V, 5VA and 5VB.
I want to route 5VA and 5VB separately, then join them in some point(s) to 5V.
I've created a net class (CLASS5V) with all 3 nets so I can create a rule allowing
CLASS5V to be short-circuited to the same class.
That works great, I can route all 3 nets together and join them... but Altium still thinks
some points are not connected - even though they are.
For example, I have two vias of 5VA net connected together with a 5VB track,
and Altium doesn't think they are connected... it still shows a ratsnets.
What is the Altium's approach to this kind of routing?
I want to route 5VA and 5VB separately, then join them in some point(s) to 5V.
I've created a net class (CLASS5V) with all 3 nets so I can create a rule allowing
CLASS5V to be short-circuited to the same class.
That works great, I can route all 3 nets together and join them... but Altium still thinks
some points are not connected - even though they are.
For example, I have two vias of 5VA net connected together with a 5VB track,
and Altium doesn't think they are connected... it still shows a ratsnets.
What is the Altium's approach to this kind of routing?