darrendoogan
Newbie level 4
Hello,
I created a layout component in ADS.
at 450MHz I simulated the input impedance for two different resistance values placed between two ports.
Using a 50 ohm resistor I measured roughly 50 ohms.
Using a large resistor I measured roughly a short.
My mesh setup is attached.
Can anyone explain why ADS is giving these incorrect values and how I can fix the problem?
Thankyou
---------- Post added at 05:13 ---------- Previous post was at 05:09 ----------
See below
I created a layout component in ADS.
at 450MHz I simulated the input impedance for two different resistance values placed between two ports.
Using a 50 ohm resistor I measured roughly 50 ohms.
Using a large resistor I measured roughly a short.
My mesh setup is attached.
Can anyone explain why ADS is giving these incorrect values and how I can fix the problem?
Thankyou
---------- Post added at 05:13 ---------- Previous post was at 05:09 ----------
See below
Last edited: