Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

about modelsim question? Please help me.

Status
Not open for further replies.

smalldog

Junior Member level 2
Junior Member level 2
Joined
May 30, 2005
Messages
22
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,441
modelsim repopen wave

Hi, All,

I meet a question when I use modelsim.
The question is:
After I finished a simulation, I can see signals in the dataflow and waveform windows. Then I save a .wlf file.
Then I closed the modelsim tools. Then I reopen the modelsim again. Then I only open the .wfl file without running others. I can only see signals in waveform windows. I can't see ang signals in dataflow windows yet.And I drag signal from other windows to dataflow windows. It is still nothing. Before I close modelsim, I can see the signals in dataflow windows. But after I close modelsim and reopne modelsim, I can't see anything in dataflow windows. Could you give me some suggestion?
Thanks a lot.
 

You should save in term of *.do file from waveform screen.
 

Thanks for your respond.
I don't understand what you mean.
I only save wave.do file from waveform windows.
Could you tell more detail?
thanks
 

anybody can help me?
Thanks a lot.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top