Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
simple method, setup->temperature... in ADE
or tools->parametric analysis...->variable name: temp, sweep temperature
if simulating with corner, tools->corners, it combines various temperatures and corners and runs them once
The corners depends on the devices u have in ur circuit,
For example , If u use transistors , resistors and capacitors , so u need to check the different corners for each for example fs transistors, slow resistors , fast capacitors and so on.
I think a good way to do so is to write an ocean script to sweep across all devices corners as well as supply and temperature , then u can check what are the worse corners for ur design and start modifying ur design to pass those corners.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
