Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Cadstar to P*otel 98SE PCB

Status
Not open for further replies.
KaSpeR

KaSpeR

Junior Member level 3
Joined
Apr 22, 2001
Messages
29
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
With Her /\
Activity points
138
Does anyone have good idea on how to convert a Cadstar pcb file to P*tel 98 SE pcb file. I ran out of ideas. Thanks for any help.
 

HI

i dont think its possible with cadstar directly.
you need to go for a third party converter.

you can try the following link.

www.logicswap.com
 

hi
have u checked all the file types which protel can accept? i think protel should be able to support dxf format, as it is the general format between ECAD packages.
cheers
skr
 

It may do but what you get in will be pretty well unusable and very unintelligent.

IMHo if you want to be able to make changes etc you would be better off starting again.

Is it a big complicated multi layer board or a small interface sort?

Roland.
 

logicswap?pulsonix?or pads translators?
they can import cadstar fils,and export edif full
GUI format.
But the importantly,they all need license expect
pads translators what need supernet
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top