Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to simulate PFD & charge pump noise?

Status
Not open for further replies.
pigkiller

pigkiller

Member level 4
Joined
May 28, 2003
Messages
70
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Location
Hangzhou
Activity points
590
pfd noise

For Behavior simulation of close loop Charge pump based PLL, PFD & charge pump noise parameter should be defined.
And I don't know how to simulate single block PFD or charge pump noise by SpectreRF. Who have experience about that pls help me.
 

simulate charge pump noise

I think the most detailed discussion about PFD noise is there

https://www.designers-guide.org/Forum/YaBB.pl?num=1037357676;start=all

I use now a method w/o spectreRF for PFD characterisation. That is because the filter after the chargepump filtering high frequency noise. The current source timing control is impacted by phase noise and this is the point where spectreRF analysis should end. All other effects are linear noise (current noise multiplied by on-time).
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top