Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
is there any way by which Atmel® AVR ISP In-System Programmer can be used to program Pics mcu
can it be used for example "with icprog" as jtag programmer?
I think u can but only with parallel programers because u will need the 14 volt for your MSCL (master clear in PIC), I think there is something like that already but i think the time you would spend searching for that can make u programmers for both PIC & AVR
Wa Alicom Salam
for ICSP you need only 5 volts not 14 v
I was trying to make use of my AVR In circuit serial programmer to program PICs that have ISP capapilities by using other software
The problem I don't have much knowledge about the programmer hardware&firmware
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
