Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Eagle - one layout, multiple schematics - possible?

Status
Not open for further replies.

grahamedriver

Newbie level 3
Joined
Aug 22, 2008
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,316
Hi

What I mean is this - I design and layout a complex, multi-purpose, circuit and it works OK. I then decide to use the layout for a sub-set of the the original functions. I can do this by simply crossing out bits of the schematic on paper, and not installing un-required components on the board.

But I would like to edit the schematic, and hence the BOM, etc so as to document the reduced function. As I delete from the schematic the components vanish from the layout - which is what I want, but so do the tracks.

Is it possible to "lock" the layout?
 

You can use "assembly variants" in the "Edit" menu. When you create a new variant you can name it, give each part a different value and also say if it is mounted or not. If the part is not mounted, it will be marked with a cross in the schematic.
 
You can use "assembly variants" in the "Edit" menu. When you create a new variant you can name it, give each part a different value and also say if it is mounted or not. If the part is not mounted, it will be marked with a cross in the schematic.


Hi

That is excellent. I thought I had looked everywhere, and Googled widely, but I wasn't looking for a name like that so I missed it.

Thanks, and thanks again.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top