Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[PIC] PICkit3 Debug Mode - Problems with Configuration bit settings

Status
Not open for further replies.
C

cnandha19

Member level 3
Joined
Aug 28, 2015
Messages
59
Helped
1
Reputation
2
Reaction score
1
Trophy points
8
Activity points
604
CONFIGURATION BITS : PIC12f683

__CONFIG(FOSC_INTOSCIO & WDTE_OFF & PWRTE_ON & MCLRE_OFF & BOREN_ON & CP_OFF & CPD_OFF);

PICkit 3 detected
Connecting to PICkit 3...
Firmware Suite Version...... 01.41.07
Firmware type......................Midrange
PICkit 3 Connected.
Target Detected
Device ID Revision = 00000003

Running...
PK3Err0040: The target device is not ready for debugging.
Please check your configuration bit settings and program
the device before proceeding.

m using pic12f683 -HITECH C Compiler
 

Since in-circuit debugging requires access to three
pins, MPLAB® ICD 2 development with a 14-pin device
is not practical. A special 14-pin PIC12F683 ICD device
is used with MPLAB ICD 2 to provide separate clock,
data and MCLR pins and frees all normally available
pins to the user.
A special debugging adapter allows the ICD device to
be used in place of a PIC12F683 device. The
debugging adapter is the only source of the ICD device.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top