Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[AVR] gsm interfacing problem

Status
Not open for further replies.
B

balvendrajat

Newbie level 5
Joined
Dec 3, 2014
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Location
Bhilwara, India
Activity points
81
how can i interface gsm sim300/sim900 with atmega16 out of these please tell me detail
1 direct connection of Rx Tx and GND.
2 using max232.
4 using a voltage divider circuit.
please give me detail of all these method
 

there is no need of max232 you can connect your module TX pin to atmega 16 RX pin and module RX pin to atmega 16 TX pin and GND to GND pin connection will do your work

and please search before posting this question answered so many time in this forum
 
Last edited:

if i directly connect tx pin of mcu to Rx pin of module then there will a chance of damage of module so please give me a resistor divider circuit
 

balvendrajat said:
if i directly connect tx pin of mcu to Rx pin of module then there will a chance of damage of module so please give me a resistor divider circuit
Click to expand...

please refer the sim300 user manual and no chance to damage of module you can use direct connection..
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top