Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have a Rain tipping bucket rain gauge as shown below in the uploaded photos. The Gauge has only two wires, thus i am wondering if those wires for the voltage source, how can i read the data??
I would think that as the gauge tips, it closes a switch. Feed the wires via a 1K resistor from a 6V supply. The voltage will be high and pulse low as the gauge tips then comes up again. Each pulse represents a certain weight of water, which in turn represents so many mm of rain fall on the collecting funnel.
Frank
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.