Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to increase the amplitude of PWM SIGNAL IN LPC1768

Status
Not open for further replies.
R

raman00084

Full Member level 6
Joined
Nov 29, 2010
Messages
362
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
4,006
I am using lpc1768 arm chip to generate PWM signal, but the ic supply voltage is 3.3v so the PWM amplitude is also 3.3v, how can i convert the 3.3v PWM signal to 5v PWM signal @ 20ma current rating to run stepper drive.
 

I am using lpc1768 arm chip to generate PWM signal, but the ic supply voltage is 3.3v so the PWM amplitude is also 3.3v, how can i convert the 3.3v PWM signal to 5v PWM signal @ 20ma current rating to run stepper drive.
Click to expand...

Hi raman00084
Use ICL7667 it will suit your aim as well .

Best Wishes
Goldsmith
 

yes but for this u need to use voltage shifter to shift 3.3 to 5v .
 

Hi,

74hct___ any non inverting circuit will do...

OR, AND, BUFFER....

Hope this helps
Klaus
 

yes but for this u need to use voltage shifter to shift 3.3 to 5v .
Click to expand...
Hi embpic
Datasheet says it's minimum input voltage can be about 2 volt so it consider high So it can be used .
Of course there are infinite ways for this purpose . such as Optocouplers / Op amps / Transistors / Gates or .....

Best Wishes
Goldsmith
 

you can use 74lvs4245 or 74act125.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top