Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] S2p file with just s11 and s22

Status
Not open for further replies.
L

Lathas

Advanced Member level 4
Joined
Oct 16, 2012
Messages
118
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Activity points
2,044
I have the VNA measured results of S11 and S21 (in ASCII format) of the resonator. Can I edit it to form s2p file and use it for ADS simulation of oscillator? Will the absence of S12 and S22 in the file cause any problem?

- - - Updated - - -

When I tried the error showed up in ADS : "Error detected while trying to read the s2p file. Unable to read required data from the touchstone file. Please ensure that the file is ASCII and correctly formatted." How can I proceed?
 

Lathas said:
I have the VNA measured results of S11 and S21 (in ASCII format) of the resonator. Can I edit it to form s2p file and use it for ADS simulation of oscillator? Will the absence of S12 and S22 in the file cause any problem?
Click to expand...

You need complete S-parameters for simulation. Your resonator is reciprocal, so you have S12=S21. Also, if it is symmetrical, S11=S22. Add these entries to the file.
 
  • Like
Reactions: Lathas

    L

    Lathas

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top