Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ICCAVR - how to read three fuse bytes?

Status
Not open for further replies.
R

rajo

Junior Member level 1
Joined
Dec 3, 2003
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Belgrade, Serbia
Activity points
195
There are three fuse bytes in some ATMEGA devices. I am working with ATMEGA162, and ICCAVR only shows two of them. Beside, I suspect that only the lower byte is displayed correctly, since I get a non-default values for the middle byte with a unused device.

Somebody with experience with this??
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top