ashish.mw
Full Member level 2
Respected all,
Hello.
I am designing a stacked and slotted antenna using IE3D. the same structure when i simulated with FEM based HFSS, gave me four resonances, the result of IE3D is also giving me four resonant points, but the problem is that the RL at two of the four frequencies is less than (above) -10dB. So i decided to assign the probe feed as the variable and tried to optimize all the four frequencies. As my structure is selective and hence narrowband, i used optimization goals as:
Im(S11)=0
Re(S11)=0
(this i read somewhere)
then after setting lower and upper bounds for feed variation, i saved the project, and then PROCESS>>OPTIMIZE.
After that what needs to be done to observe the optimized plot. Can i directly see the results as
PROCESS>>DISPLAY>>s PARAMETER...
??
please help with the next procedures.
I shall be highly obliged.
Thanks in advance.
Hello.
I am designing a stacked and slotted antenna using IE3D. the same structure when i simulated with FEM based HFSS, gave me four resonances, the result of IE3D is also giving me four resonant points, but the problem is that the RL at two of the four frequencies is less than (above) -10dB. So i decided to assign the probe feed as the variable and tried to optimize all the four frequencies. As my structure is selective and hence narrowband, i used optimization goals as:
Im(S11)=0
Re(S11)=0
(this i read somewhere)
then after setting lower and upper bounds for feed variation, i saved the project, and then PROCESS>>OPTIMIZE.
After that what needs to be done to observe the optimized plot. Can i directly see the results as
PROCESS>>DISPLAY>>s PARAMETER...
??
please help with the next procedures.
I shall be highly obliged.
Thanks in advance.
