varun_agr
Newbie level 5
Sir
I am trying to use FFT 5.0 core in xilinx10.1 as follows for 50 hz SinWAVE(THROUGH ADC)for noise removal
1. 64 Transform size
2. Radix-2 burst mode
3.I/p data width 8 bit
4.Scaled
5. Natural order(without cylix prefix)
I want to know what is the value of scale_sch for FFT and IFFT.
Further I want to use inverse FFT for the O/P fft i.e XK_REAL AND XK_IMA.
and display the same sine wave via DAC. So what is the procedure after FFT.
Should I remove all real and imaginary except fundamental frequency i.ecalculated by xk_index.
and give this to FFT core(for inverse FFT) or anything else, kindly suggest me
bye
Varun
I am trying to use FFT 5.0 core in xilinx10.1 as follows for 50 hz SinWAVE(THROUGH ADC)for noise removal
1. 64 Transform size
2. Radix-2 burst mode
3.I/p data width 8 bit
4.Scaled
5. Natural order(without cylix prefix)
I want to know what is the value of scale_sch for FFT and IFFT.
Further I want to use inverse FFT for the O/P fft i.e XK_REAL AND XK_IMA.
and display the same sine wave via DAC. So what is the procedure after FFT.
Should I remove all real and imaginary except fundamental frequency i.ecalculated by xk_index.
and give this to FFT core(for inverse FFT) or anything else, kindly suggest me
bye
Varun