Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Nexys 3 board not detected by Digilent Adept 2 software

Status
Not open for further replies.
C

ChosenOreo

Newbie level 1
Joined
Dec 27, 2011
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
My Nexys 3 board is not detected by the Diligent Adept 2 software. Is there any way I can test if the board is not working or if it is just not being detected?

EDIT: Solved - The jumper was on the wrong pins..
 
Last edited:

ChosenOreo said:
My Nexys 3 board is not detected by the Diligent Adept 2 software. Is there any way I can test if the board is not working or if it is just not being detected?

EDIT: Solved - The jumper was on the wrong pins..
Click to expand...

Please guide me with this........ what jumper you are talking about????

i am facing same issue!
 

You can RTFM here. See Configuration on page 2. As you can see in that fine piece of documentation, jumper 8 is what he is talking about.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top