Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

monitor voltage of solar charge controller using a arduino

Status
Not open for further replies.
R

robismyname

Full Member level 6
Joined
Jan 17, 2008
Messages
390
Helped
11
Reputation
22
Reaction score
9
Trophy points
1,298
Location
Central Florida
Activity points
4,603
Im working on a home project using solar panels and a morningstar PWM charge controller. My goal is to somehow connect the charge controller to my arduino ethernet controller to monitor the voltage of the charge controller. The only problem is that looking at the electrical diagram of the charge controller i dont seen any electrical nodes or circuitry that i can connect to a i/o pin of my arduino. Can anyone offer any ideas? Is this possible with the circuitry inside the charge controller?


**broken link removed**
**broken link removed**
 

Use just 1-wire no need for Arduino Pinguino. :wink:

Do You whant this to be log at SD card with LCD ?
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top