Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Is there an optimal method to tune PA’s loading impedance

Status
Not open for further replies.

joshuacp

Member level 4
Joined
Jun 25, 2005
Messages
76
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,288
Activity points
2,091
Dear all,
Recently, I am working with a power Amplifier (PA) tuning. I want to know whether there is an optimal method to tune PA.

I want to import the PCB file to ADS (Advanced Design System). The example PCB file is shown in Fig. 1. Then in the ADS file, I connect a 50 Ohms load to A’ point, while the other port of 50 Ohms is connected to ground, then simulate the load impedance looking at the point B’.

Now, my question is how to convert the PCB file to ADS and how to simulate above simulation in ADS? Could someone give me any example files?

PS: my PCB file is allegro file of cadence.
Best Regards

Joshua
 

Attachments

  • PA tuning.pdf
    41.2 KB · Views: 86

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top