Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

enquiry of what is CON10AP

Status
Not open for further replies.
B

bramin19

Member level 1
Joined
Jan 18, 2011
Messages
36
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,512
Do any one have idea of what is CON10AP?


please i am in need of the component.
In the circuit it is designated as J1.


so, i think that it is a jumper.

It has been connected between microcontroller and DB25 connector.
 

ckshivaram said:
its the 10pin connector....

you can use box type connector with FRC cable
only 5 pins are used out of 10 pins.....
power , ground,..... pgc, and pgd... and the last mclr/vpp....
Click to expand...




Thank u for ur response.
Can u tell what is the use of those pins ? It is useful.
Can i use any 10 pin connector or this has any special function to do?

The use of pins here are

pin 2 - VBE
pin 4 - SCK
pin 6 - MOSI(Master Out Slave In)
pin 8 - Reset
pin 10 - MISO(Master In Slave Out)
pin 1 - GND
 

I am not able to find the CON10AP in the Hyderabad market.


Can any one suggest the alternative to this one? its urgent....
 

ckshivaram said:
you can any connector like FRC or any 5 pin connector... dont worry about the connector
Click to expand...





Thank you. so u say to ignore the connector.

can i connect directly DB 25 t0 Micro controller?
 

why such a big connector..... you need only 5 pins for those signals... you can use any simple connector or a DB9 connector but you should follow the pin wiring as per circuit
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top