Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Modifying an oscillator circuit

Status
Not open for further replies.
F

Flying Jester

Newbie level 2
Joined
Dec 8, 2010
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,295
Hey.

Can someone help me out? I need to make a 5-20 Hz squarewave (ideally) oscillator. Not variable, but fixed anywhere between 5 and 20 Hz. I'd like to only use basic components--no ICs, no inductors; just capacitors, resistors and transistors.

I've found quit a few 2 Hz oscillators online (like the one on the left in the PDF I included). How can I change the circuit to speed up the oscillation?
 

Attachments

  • OSC4.pdf
    7.3 KB · Views: 60

Simply change the RC time constants accordingly, either reduce all capacitances or resistors by a factor of ten.
 
Alright. I knew it wouldn't be difficult, but I wasn't quite sure how to proceed.

Also, I meant to say the RIGHT, not left.

Just considering my options here, how low power can a 555 operate on? And will it change the timing characteristics at the extrema?
 
Last edited:

The CMOS version of 555 has a supply current demand in a 100 uA order of magnitude, so it can't compete with the low power transistor circuit. 555 is designed for up to MHz rate, so it needs a higher bias current. But the output will a clean rail-to-rail squarewave.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top