Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CST Circularly Polarized Plane Wave + Plus Scattering Parameters

Status
Not open for further replies.
B

budder8818

Junior Member level 3
Joined
Sep 15, 2010
Messages
25
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
New Jersey, USA
Activity points
1,476
I'm trying to learn how to setup circular polarization in CST 2009 Microwave Studio for a plane wave. Assume a very simple dipole atten. Ground plane with feed (waveguide port over this feed), dielectric slab, dipole and then waveguide port 2 in front of the attn. How could I send a plane wave circularly polarized from port 2 in the negative z direction. Please look at the diagram. And obtain scattering parameters?

Thank you

Diagram.jpg
 

Did you solve this problem? If you did, can you please post your solution. Thanks.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top