Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

P@ds Power pcb copper poor

Status
Not open for further replies.
MCMC

MCMC

Advanced Member level 4
Joined
Feb 2, 2002
Messages
101
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
699
pcb copper flood

Hi all
I need help
How to route through a copper poor in power pcb or blaze route ??
 

MCMC

type 'PO' and enter key (modeless command) in P0wer_PCB and Bl aze.
The hatch of copper disappear, then route ... freely !
Let me know. Skywalker.
 

Hi skywalker

thanks for reply, this is a great tip, but I need to maintaing the copper poor, no delete it,
 

Hi MCMC

with modeless command 'PO' the pour disappear.
You can route, but copper pour flood are need
after routing.

Let me know if i not undertstand the question.
Best Skywalker.
 

in p@ds if u select the poor and then route it in the drc mode then the pour get unfill and remain as it is u have to repour to to make the drc clean. the ground plain automatically will not push to clear the drc
 

Hi skywalker
Thanks I understand now !!!! I test it and work fine !!!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top