Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to cut PCB for clearence in altieum

Status
Not open for further replies.
D

darla1

Full Member level 3
Joined
May 21, 2008
Messages
161
Helped
26
Reputation
52
Reaction score
14
Trophy points
1,298
Location
India
Activity points
2,104
how to cut pcb

dear all

can anybody tell me how to cut PCB between two pads for clearence..e.g

i would like cut between MOSFET drain and source pin to maintain clearance..i am not able to do this...

plz help me.

darla
 

pcb clearence

I'm not quite sure what you want. Do you want to put a slot in the board?

What version of Altium software are you using?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top