Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

conformal patch antennas in CST

Status
Not open for further replies.
S

shahid78

Full Member level 5
Joined
Jul 29, 2006
Messages
288
Helped
34
Reputation
68
Reaction score
14
Trophy points
1,298
Activity points
3,294
hi

how to model conformal microstrip patch antennas in CST MWS?

i was tryin to model a cylinder and then cutting it . but after that i am stuck up how to proceed with the design of ground plane . subsstrate and finally patch


anyone have experience of modeling non planar patch antennas would be of great help


regards
 

In CST 2009...you can directly bend your tructure ( microstrp patch) on the surface
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top