Anton89
Member level 3
Hello,
I have an evaluation board of RF amplifiers. The board works with 5V supply, but it can work with 3V by changing a resistor.
This resistor is a very small SMT component.
Same board has two kind of mathing network, that can be changed by substituting the inductors and capacitors. This components are also very very small.
My question is this: for prototyping purpose, should a good RF enginner have also soldering capability for very little components? I know the soldering may also impact to RF system performance.
Many thanks.
Bye.
Antonio
I have an evaluation board of RF amplifiers. The board works with 5V supply, but it can work with 3V by changing a resistor.
This resistor is a very small SMT component.
Same board has two kind of mathing network, that can be changed by substituting the inductors and capacitors. This components are also very very small.
My question is this: for prototyping purpose, should a good RF enginner have also soldering capability for very little components? I know the soldering may also impact to RF system performance.
Many thanks.
Bye.
Antonio