Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

pcb design for 15x7 led matrix

Status
Not open for further replies.
S

sukhoimg

Junior Member level 1
Joined
Aug 24, 2012
Messages
19
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,399
hello
i'am trying to design a pcb for my led matrix , i'am using 5x7 matrix from lite_on(datasheet is linked below) and i want to palce 4 matrices,i'am using ARES to design the pcb on a single layer but i have a problem when the routes cross each other what should i do ?View attachment IC-ON-LINE.CN_ltp2157ae_637852.pdf
 

Either use another layer or use jumpers.
jumpers can be wire links,0 ohm resistors or some other component.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top