Sajjadkhan
Full Member level 5
- Joined
- Sep 25, 2010
- Messages
- 307
- Helped
- 17
- Reputation
- 34
- Reaction score
- 16
- Trophy points
- 1,298
- Location
- Rawalpindi,Pakistan
- Activity points
- 4,199
I have an old printer laserjet 1200 series by hp and i use it for toner transfer only. its 600dpi. problem is if i lay a pcb track of width more that 50th then it starts missing few tiny like dots and same happens when i have to cover unused area with copper. after preparing the pcb if i look it against the light then i see tinny areas and some bigger areas where light can pass through easily and it dosent look good. do i need higher dpi or a denser toner printer? what printer do you guys recommend?