Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Ads spice error when simulating bias conditions

Status
Not open for further replies.
L

lebed

Newbie level 6
Joined
Mar 3, 2004
Messages
11
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,281
Activity points
100
@ds spice problem

Dear all,

I tryed to import Spice Model BFP-520 from Ifineon to @ds.
When I simulate bias conditions, I get message: You may want to increase the explosion current in the device model.
But the explosion current (Imax) is not defined in BFP-520 spice model.

Somebody any idea, what I can do

Thanks for help!!!
 

@ds spice problem

if the explosion current (Imax) not defined,the software use default value.increase the Imax value from its default value and try again.
 

Re: @ds spice problem

Thank you for answer.

I tryed to increase Imax in the SPICE model and get no warnings,
But the result of simulation are wrong. I get Ic = 130 mA.
Must be about 10 to 20 mA.
 

@ds spice problem

could you check the terminal of the model in @ds, is it correctly connected? or have you biased it correctly? I>Imax normally happened at short circuit.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top