Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Microwave office [Help required]

Status
Not open for further replies.

Element7k

Advanced Member level 1
Joined
May 7, 2003
Messages
434
Helped
26
Reputation
52
Reaction score
19
Trophy points
1,298
Location
TherealLapland
Activity points
4,278
Hi all,

I have a problem with importing graph into Microwave office and hope that someone can help.

I have receive some impedance measurements for an antenna. The data of real impedance and imaginary impedance are in seperate files. No s1p files. How do I import it into microwave office to plot it in the smith chart. I have tried putting them into a text file 1st column freq, 2nd column real and 3rd column img and imported it into MWO using raw data. However, when I try to plot the smith chart, MWO keep saying measurement not compatible with graph type.

Anyone has any ideals what I've done wrong here. Your help will be very much appreciated. Thanks in advance.

Regards,
Element7k
 

Hi Element7k,

If you allready prepared the text file with the 3 colums, add the standard header for the snp files ( for the touchstone format definition see the link below, or search in the mwo help), and you can import it as a s1p parameter file. (you rename the extension to s1p).

for example:

!FREQUENCY (MHZ), REAL S11 (OHMS), IMAGINARY S11 (OHMS) NORMALIZED
!
# MHZ Z RI R=50
50 3.799 -0.5294
300 2.2144 -1.7168
500 1.3078 -1.5144
750 0.7558 -1.0924
1200 0.3268 -0.489

the line in red is mandatory, the comment after all lines started with ! are skipped, so you can put there your remark, notes.

link:
hxxp://www.eda.org/pub/ibis/connector/touchstone_spec11.pdf

I hope this info is usefull.

rgds,
Al
 

    Element7k

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top