Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[How to] Lumped elements conversion into Distributed elements

Status
Not open for further replies.

kela3kela

Full Member level 4
Full Member level 4
Joined
Apr 30, 2009
Messages
191
Helped
5
Reputation
10
Reaction score
5
Trophy points
1,298
Activity points
2,502
Hello members,

I would like convert the lumped elements in the following design to equivalent distributed elements for fabrication purposes. Can someone kindly suggest some methods, online tools or simulators for that matter?

Untitled.png

Awaiting replies,
Regards
 

L1:Short circuited stub
L2:MS Transmission Line
C3:Open circuited stub
C4:no equivalent..
 

@BigBoss Thankyou for the T-Lines description. But can you kindly let me know which method or simulator u used for the design?
 

Hello members,

I would like convert the lumped elements in the following design to equivalent distributed elements for fabrication purposes. Can someone kindly suggest some methods, online tools or simulators for that matter?

View attachment 116047

Awaiting replies,
Regards

Using what for waveguides? Optical fiber?

Due to the fact that you're operating around 1 GHz, I would recommend something like microstrip or coplanar waveguide on FR-4, but since the values of the components aren't specified, it's hard to make a recommendation.
 

@BigBoss Thankyou for the T-Lines description. But can you kindly let me know which method or simulator u used for the design?

You don't need a simulator...Just a piece of paper and a pencil..
 
Good one :).. So whats the method to work on paper
 

Just a piece of paper and a pencil..

... and a lot of PCB area. There are these cases where distributed elements make sense. But here at 1GHz, it is much better to use small SMD instead of large transmission line structures.
 

Hello members,

I would like convert the lumped elements in the following design to equivalent distributed elements for fabrication purposes. Can someone kindly suggest some methods, online tools or simulators for that matter?

View attachment 116047

Awaiting replies,
Regards

Any standard microstrip design book will have the details for implementing those L and C on planar geometries..You can refer to a solved example in Pozar book (Chapter on filters) where the process of implementing series and shunt L and C is explained..
 
Thank you all for ur kind replies.
 

You can either transform the lumped components into TLs or stubs. Only series L and shunt C can be transformed into TLs, stepped impedance lowpass filters are typical examples of lumped>TL transformation. Because you have series C and shunt L, TL transformation is not applicable.
You need to perform stub transformation, see Richards transformation formulas, it replaces the lumped components with stubs(short or open). Once all the components transformed into stubs you need to go one step ahead and transform the series stubs(because series stubs can not be implemented in microstrip) into shunt stubs using Kuroda identities. After all, you end up with all shunt stub filter, their width(trace width) may or may not be practical! If you are happy with them you can manufacture it.

All these efforts may not be necessary to make a design at 1 GHz. Working with lumped components sounds better.
 
@ferdeem ,Thanks for the detailed reply :)
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top