Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi to all,
i need help for a led driver...these are my features
1. current up to 250mA
2. 2 series led max
3. 24V
4. output linear current regulation with a pwm micro output (3.3V or
5V)
5. simple for hand soldering
i haven't found an IC able to do what i want...do you know one?
Thanks for your answer: with a correct Vdd i'm able to program...my firmware works good! I have now another problem: i'm not able to debug. During programming, i see an ICD0083 error: Debug: Unable to enter debug mode. What's wrong?
thanks in advance
Hi,
i have some problems regarding PIC24FJ32GB002 programming (and debug) with ICD2. I've used Mplab 8.63 and this schematic
**broken link removed**
During programming, this pic is recognized: but a fail-salf test appears. These are obtained values:
Target Vdd High
Module Vpp High
MCLR Gnd...
d class amp
Hi,
I have a problem with this class D amplifier:
https://focus.ti.com/docs/prod/folders/print/tpa2005d1.html
I've used it as in Figure 34 pag.11 of datasheet:
Ri=150kohm=>GAIN=2
Ci=3.3nF
IN- is connected (with RC high-pass filter) to a micro DAC
DAC output is between 0 and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
